To configure the scanner, please follow the steps below:
Turn on the scanner.
Go to the iPad settings ⚙️ and then to the Bluetooth tab.
The scanner appears in the device list as Socket Device-Prelnit, turn it on.
Then go to General then Keyboard and press Keyboards again.
Press Add Keyboard and select English (U.S.). Only the English (US) keyboard should remain in your keyboard list
Scan the "Factory Reset" barcode below with your scanner.
The Socket will make a sound or a beep.
Switch on the Socket then scan the HID-Keyboard barcode.
If the Socket beeps, it is configured.
Now, you will have to activate the Product Scan module in your Back-office (Configuration -> Your Modules -> Configuration of the order intake).
Then go to your application and press the sync button then click on Settings then English --> Configure Scanner Keyboard :
Select English then scan with your scanner the barcode that appears on your screen
That's it! Your scanner is now configured!
Warning: the scanner is configured as a wireless keyboard, you can not use the alphanumeric keyboard while it is connected to the iPad with this mode.
To make your keyboard reappear, you have to double-click on the little power button of your scanner.